Comparison of Wet Abrasive Blast (WAB) and Dry Abrasive Blast Cleaning
Posted on 04. Feb, 2016 by admin in Flash Rust, Gallery
There are many methods of wet abrasive blast cleaning (WAB) in surface preparation to remove coatings.
Since the 1980’s, Carolina Equipment and Supply Co. (CESCO) has been supplying WAB equipment along with recycling methods.
Recently CESCO sent me two youtubes to directly compare traditional dry abrasive blast cleaning and Wet Abrasive Blast Cleaning using their AquaMiser (TM) equipment. I would like to share the youtubes with you.
===
Dry Blast (Traditional Abrasive Blast Cleaning) Surface Preparation
Parameters: 375 cfm compressor at 100 psi using a # 8 venturi nozzle
The panel was 54” x 28” (137 cm x 71 cm) (10.5 sq. feet) and was coated with an epoxy primer and poly urethane topcoat.
Abrasive: Dupont Starblast 101 using 18 lbs per minute at a cost of $.22 cents per lb (total abrasive cost $23.76)
Time: 6 minutes
Dry Abrasive Blast Cleaning
===
Aqua Miser Wet Abrasive Blast Cleaning (Surface Preparation)
Parameters: 35,000 psi 3 gpm using the F40 Abrasive Fan Gun with a 15 degree tip
The panel was 54” x 28” (137 cm x 71 cm) (10.5 sq. feet) and was coated with an epoxy primer and poly urethane topcoat.
Abrasive: Dupont Starblast 101 using 2lbs per minute at a cost of $.22 cents per lb (total abrasive cost was $1.32)
Time: 2 minutes 43 seconds
Wet Abrasive Blast Cleaning (CESCO)
